Stryker Isolibrium 2971 Operation Manual

English
EN
www.stryker.com 2971-209-001 REV C 1-15
Operation
Activating and resetting CPR (Continued)
Figure 1-7: CPR activation
Figure 1-8: CPR reset
To reset for CPR, pull down on red CPR strap (Figure 1-8 on page 1-15). The support surface will begin to reinflate.
Relocating the support surface
Relocating the support surface is for the purpose of cleaning or moving to another InTouch bed frame.
WARNING
• Do not move the support surface without assistance.
• Do not use the support surface as a transfer device to avoid the risk of patient injury.
Prerequisite: Minimum of two operators are required to relocate the support surface and setup this product.
1. Make sure that there is not a patient on the support surface.
2. Remove the linens.
3. Unplug the power cord for the support surface from the foot end auxiliary power outlet.
4. Unplug the support surface connector.
5. Remove the headboard and footboard
6. Position an operator at each end of the support surface and remove the support surface and relocate.
Note: Use all four handles when relocating the support surface.
Note: See (Installation on page 1-10) of the support surface.
7. Reinstall the InTouch headboard and footboard.

Stryker Isolibrium 2971 Specifications

General

Brand	Stryker
Model	Isolibrium 2971
Category	Medical Equipment
Language	English