Stryker LIFEPAK 15 User Manual

Page 11
LIFEPAK 15 Monitor/Defibrillator
SpO
2
1. Press ON
2. Connect the pulse
oximeter cable to the
monitor and sensor
3. Attach sensor to ring
nger of the non-
dominant hand and
orient so cable is on
back of patient’s hand
4. Observe the pulse bar
for uctuation, amplitude
of the pulse bar indicates
relative signal quality
5. Conrm SpO
2
reading
appears and is stable
SpCO & SpMet
Perform steps 1-5, then:
6. Verify that SpCO / SpMet
sensor is in use; ONLY
Rainbow
®
sensors are
capable of reading
SpCO / SpMet
7. Rotate Speed Dial to
outline SpO
2
area
8. Select parameter
9. Select SpCO or SpMet.
Selected value displays
for 10 seconds.
CO2
SpO2
NIBP
ECG
P1
P2
SpO
2
/ SpCO / SpMet
monitoring procedure
Note: If SpCO or SpMet reading is above
normal limits (SpCO >10% , SpMet >3%)
an Advisory message occurs.

Stryker LIFEPAK 15 Specifications

General

Battery	Lithium-ion
Defibrillator	Yes, biphasic
Defibrillation Energy Range	1-360 J
SpO2 Monitoring	Yes
NIBP Monitoring	Yes
EtCO2 Monitoring	Yes
Invasive Pressure Monitoring	Yes
Temperature Monitoring	Yes
Connectivity	Bluetooth, WiFi
ECG Monitoring	12-lead