Stryker Neptune 2 - Control Panel Operation; Control Panel Buttons and Dials

6 www.stryker.com
2008/04 0702-014-700 Rev-B
Troubleshooting Guide*
PROBLEM CAUSE ACTION
PowerswitchdoesnotilluminateintheON
position.
Powercordisnotconnectedsecurely. Connectthepowercordsecurely.
Waterinlethoseisleaking. Waterinlethoseisdamaged. Contact Stryker.*
Wasteoutlethoseisleaking. Wasteoutlethoseisdamaged. Contact Stryker.*
Sporadicelectricalinterferenceisexperienced. Electricalnoiseispresent. Turnoffalltheelectricalequipmentintheroom.
Relocatetheelectricalequipmenttomaximizethe
distancebetweentheequipment.Increasespatial
distance.
Plugequipmentintodifferentoutlets.
*DONOTservicethisequipment.Ifyourequireservice,contactyourStrykersalesrepresentativeorcallStrykerNeptunecustomerserviceat1-800-550-7836.OutsidetheUS,
contact your nearest Stryker subsidiary.