Stryker Secure 3000 - Page 3

Introduction
2
INTRODUCTION
This manual is designed to assist you with the operation of the Secure 3000 Bed. Read it thoroughly before
using the equipment.
SPECIFICATIONS
Maximum Weight Capacity 500 pounds (227 kilograms)
Overall Bed Length/Width 93” x 42–1/2” (with siderails up) – 36” (with siderails down)
238 cm. x 109 cm. (with siderails up) – 92 cm. (with siderails down)
Patient Sleep Surface 84” x 35” – 215 cm. x 90 cm.
Bed Height (to top of seat litter) 16” (Low) x 29–1/2” (High) – 41 cm. (Low) x 76 cm. (High)
Knee Gatch Angle 0_ to 40_
Fowler Angle 0_ to 60_
Trendelenburg/Reverse Trendelenburg –11_ to +11_
Weigh System Accuracy (optional
equipment)
 1% of total patient weight while the bed is level and up to a 4_
or –4_ angle
 3% of total patient weight from 5_ to 11_ angle or –5_ to –11_
angle
Electrical Requirements – all electrical
requirements meet UL 544 specifica-
tions.
115 VAC, 60 Hz, 7.0 Amp. w/o outlet
115 VAC, 60 Hz, 12.0 Amp. w/outlet
230 VAC, 50/60 Hz, 4.0 Amp.
WARNING / CAUTION / NOTE DEFINITION
The words WARNING, CAUTION and NOTE carry special meanings and should be carefully reviewed.
WARNING
The personal safety of the patient or user may be involved. Disregarding this information could result in injury
to the patient or user.
CAUTION
These instructions point out special procedures or precautions that must be followed to avoid damaging the
equipment.
NOTE
This provides special information to make important instructions clearer.
WARNING
Always apply the caster brakes when a patient is getting on or off the bed. Push on the bed to ensure the
brakes are securely locked. Always engage the brakes unless the bed is being moved. Injury could result
if the bed moves while a patient is getting on or off the bed.