Siderail Operation Guide
16
OUTSIDE SIDERAIL FUNCTION GUIDE (CONTINUED)
Push to activate auto or manual mode of the Dynamic Mattress System.
LED will light to indicate selected mode and/or possible air leak.
" This panel is optional equipment.
LED will blink when the brakes are not set.
Push to activate Nurse Call.
" This panel is optional equipment.
DYNAMIC MATTRESS SYSTEM USAGE (OPTIONAL EQUIPMENT)
1. The system can be set in either ”AUTOMATIC” or ”MANUAL” modes. The ”AUTO/MAN” switch is used
to activate both modes. When Automatic mode is selected, the ”AUTOMATIC” LED on the siderail control
panel will be on. When Manual mode is selected, the ”MANUAL” LED on the siderail control panel will
be on. The “AUTO/MAN” switches are located on the control panels on the outside of the head end side-
rails (see above).
2. When the Automatic mode is selected, the firmness of the mattress will adjust automatically as needed.
When the Manual mode is selected, the firmness of the mattress can be adjusted by the patient or the
hospital clinical staff. The ”FIRM” and ”SOFT” switches are located on the control panels on the inside
of the head end siderails (see page 14).
NOTE
The mattress power cord must be plugged into the bed for the mattress to operate. See page 7 for ”DMS
Port” location.
To Next Page
Loading...
