Litter Operation Guide
11
NIGHT LIGHT USAGE (Optional Equipment)
The bed may be equipped with two optional night
lights (A) to illuminate the floor area around the
bed.
There is a master switch at the foot end of the bed
on the right side that turns both lights on and off.
Each light also has a switch to control the individu-
al light.
NOTE
If the switch is turned off on either of the individual
lights, the master switch will not control that light.
PATIENT RESTRAINT STRAP LOCATIONS
The bed is equipped with 12 separate locations for installing patient restraint straps. The ”cutouts” in the bed
top are located directly across from each other (on both sides of the bed).
WARNING
Improperly adjusted restraint straps can cause serious injury to a patient. The clinician must use her/his
judgement to determine proper use of restraint straps and restraint strap locations.
Clean Velcro AFTER EACH USE. Saturate Velcro with disinfectant and allow disinfectant to evaporate. (Ap-
propriate disinfectant for nylon Velcro should be determined by the hospital.)
NURSE CALL BACK–UP BATTERY
To prevent a low battery condition when the bed is not plugged in, position the cord out switch at the head
end of the bed to the off position. The switch is identified by the label shown below. If the switch is not posi-
tioned as shown below and the bed power cord and pendant cord are unplugged, the life of the back–up bat-
tery will be significantly reduced.
If the power light (located on the foot board) is flashing, the Nurse Call battery needs to be replaced. The
battery is located on the patient’s left side at the head end of the bed. No tools are required to replace the
battery. Unplug the bed power cord from the wall socket and replace the battery.
FOOT END
To Next Page
Loading...
