pg 37
blueSky - reverberator
Live Edit Controls - Quick Reference
blueSky provides adjust several secondary functions that are available
on the controls� (Also, see
“Live Edit Functions” on page 7)
� Live
Edit functions are saved per preset�
1 Press and hold the ON footswitch until both LEDs blink to enter Live
Edit mode�
2 Release the footswitch and use the controls as described below�
3 Press ON footswitch to store your setting and exit Live Edit mode�
BOOST/CUT
See page 7 for an
illustrated description�
Turn the MIX knob to set a level boost or cut when
the pedal is engaged� The ON LED changes from
GREEN (-3dB to unity) to AMBER (unity to +3dB) as
the knob is adjusted
Unity gain is at 12 o’clock (default)
MIDI EXPRESSION
See page 8 for an
illustrated description�
Set the VERB type switch to plate (up) or to spring
(down)—status is momentarily shown on both
LEDs
• plate position: ON, BLUE (default)
• spring position: OFF, RED
NOTE: Also see “Expression Pedal Setup” on page 14 to configure your
pedal functionality per preset�
To Next Page
Loading...
