pg 9
blueSky - reverberator
Power Up Modes
Input Level
Selects the input level that is routed to the effect processing�
1 Press and hold the ON footswitch while powering up blueSky� Once
both LEDs flash, release the footswitch�
2 Turn the DECAY (INPUT LEVEL) knob to select the Input Level mode�
Both LEDs will change color to indicate the current status as you
turn the knob�
• Instrument: GREEN (default) - Input headroom is set for an in-
strument level source, such as a guitar or a bass�
• Line: RED - Input level is set for a line level source, such as a
keyboard or synthesizer� 10dB of headroom is added�
3 Press either footswitch to store the Input Level setting and begin
using blueSky�
NOTE: The Input Level setting persists across power cycles and is not saved
per preset�
To Next Page
Loading...
