Strymon cloudburst - Knobs and Switches

Controls - continued
3. MIX
Controls the reverb mix from full
dry at minimum to full wet at
maximum. A 50/50 mix occurs
at approximately 3 o’clock on
the knob.
4. PRE-DELAY
Sets the amount of time before
the reverberated signal appears.
For most natural results, use
lower MIX settings when using
higher PRE-DELAY.
5. TONE
Adjusts the high-end content of
the reverb. Lower settings create
darker, warmer reverberation.
Higher settings are bright & crisp.
NOTE: Also aects the presence
of the ENSEMBLE eect.
6. MOD
Adds a wide range of
modulation to the reverberated
signal. Modulation is o at the
minimum setting.
7. FOOTSWITCH
Engages and disengages the
eect. Red LED indicates the
eect is engaged.
Support
Download the Full User Manual
strymon.net/support/cloudburst
Questions & Technical Support
support@strymon.net