Strymon sunset - Factory Reset Procedure; Factory Settings Overview

Sunset - Dual Overdrive
®
pg 11
Factory Reset
Press and hold the
B footswitch during
power up. Both LEDs
will blink.
1
Release the footswitch and turn the A channel LEVEL knob
from 0-100% and back two (2) times. The A channel LED will
change to AMBER at the extremes of the knob range and
blink RED to indicate that the reset is taking place.
Once the A channel LED stops blinking RED, the reset is
complete and Sunset is ready for use.
2
FACTORY SETTINGS
• EXP Input Jack: Assigned to work in VOLUME PEDAL mode.
• Expression Pedal Mode Assignment: Assigned to control both DRIVE knobs simultaneously.
• Noise Gate: OFF
• Bypass Mode: True Bypass
Restore the pedal to factory power up modes and secondary functions.