Studer Innotec SA
Quick guide RCC-02/-03
Quick guide V 6.1.0 21
VarioTrack parameter description
Contact active on event (AUX 2)
VarioTrack is OFF (AUX 2)
Battery undervoltage (AUX 2)
Battery overvoltage (AUX 2)
PV error (48h without charge) (AUX 2)
Bulk charge phase (AUX 2)
Equalization phase (AUX 2)
Periodic absorption (AUX 2)
Contact active according to battery voltage (AUX 2)
Battery voltage 1 activate (AUX 2)
Battery voltage 1 (AUX 2)
Battery voltage 2 activate (AUX 2)
Battery voltage 2 (AUX 2)
Battery voltage 3 activate (AUX 2)
Battery voltage 3 (AUX 2)
Battery voltage to deactivate (AUX 2)
Delay to deactivate (AUX 2)
Deactivate if battery in floating phase (AUX 2)
Contact active according to battery temperature (AUX 2)
With BSP or BTS
Contact activated with the temperature of battery (AUX 2)
Contact activated over (AUX 2)
Contact deactivated below (AUX 2)
Only activated if the battery is not in bulk phase (AUX 2)
Contact active according to SOC (AUX 2) Only with BSP
Contact activated with the SOC 1 of battery (AUX 2)
Contact activated below SOC 1 (AUX 2)
Contact activated with the SOC 2 of battery (AUX 2)
Contact activated below SOC 2 (AUX 2)
Contact activated with the SOC 3 of battery (AUX 2)
Contact activated below SOC 3 (AUX 2)
Contact deactivated over SOC (AUX 2)
Delay to deactivate (AUX 2)
Deactivate if battery in floating phase (AUX 2)
Reset all settings (AUX 2)
To Next Page
Loading...
Need help?
General
