Studer Innotec SA
Quick guide RCC-02/-03
20 V 6.1.0 Quick guide
VarioTrack parameter description
Equalization phase (AUX 1)
Periodic absorption (AUX 1)
Contact active according to battery voltage (AUX 1)
Battery voltage 1 activate (AUX 1)
Battery voltage 1 (AUX 1)
Battery voltage 2 activate (AUX 1)
Battery voltage 2 (AUX 1)
Battery voltage 3 activate (AUX 1)
Battery voltage 3 (AUX 1)
Battery voltage to deactivate (AUX 1)
Delay to deactivate (AUX 1)
Deactivate if battery in floating phase (AUX 1)
Contact active according to battery temperature (AUX 1)
With BSP or BTS
Contact activated with the temperature of battery (AUX 1)
Contact activated over (AUX 1)
Contact deactivated below (AUX 1)
Only activated if the battery is not in bulk phase (AUX 1)
Contact active according to SOC (AUX 1) Only with BSP
Contact activated with the SOC 1 of battery (AUX 1)
Contact activated below SOC 1 (AUX 1)
Contact activated with the SOC 2 of battery (AUX 1)
Contact activated below SOC 2 (AUX 1)
Contact activated with the SOC 3 of battery (AUX 1)
Contact activated below SOC 3 (AUX 1)
Contact deactivated over SOC (AUX 1)
Delay to deactivate (AUX 1)
Deactivate if battery in floating phase (AUX 1)
Reset all settings (AUX 1)
Combination of the events for the auxiliary contact (AUX 2)
Contact activated in night mode (AUX 2)
Activated in night mode (AUX 2)
Delay of activation after entering night mode (AUX 2)
Activation time for the auxiliary relay in night mode (AUX 2)
Contact active with a fixed time schedule (AUX 2)
Contact activated with fixed time schedule (AUX 2)
To Next Page
Loading...
Need help?
General
