Studer Innotec SA
Quick guide RCC-02/-03
Quick guide V 6.1.0 25
VarioString parameter description
Contact activated with the SOC 2 of battery (AUX 1)
Contact activated below SOC 2 (AUX 1)
Contact activated with the SOC 3 of battery (AUX 1)
Contact activated below SOC 3 (AUX 1)
Contact deactivated over SOC (AUX 1)
Delay to deactivate (AUX 1)
Deactivate if battery in floating phase (AUX 1)
Reset all settings (AUX 1)
Combination of the events for the auxiliary contact (AUX 2)
Contact activated in night mode (AUX 2)
Activated in night mode (AUX 2)
Delay of activation after entering night mode (AUX 2)
Activation time for the auxiliary relay in night mode (AUX 2)
Contact active with a fixed time schedule (AUX 2)
Contact activated with fixed time schedule (AUX 2)
Contact active on event (AUX 2)
VarioString is ON (AUX 2)
VarioString is OFF (AUX 2)
Battery undervoltage (AUX 2)
Battery overvoltage (AUX 2)
PV error (48h without charge) (AUX 2)
Bulk charge phase (AUX 2)
Equalization phase (AUX 2)
Periodic absorption (AUX 2)
Contact active according to battery voltage (AUX 2)
Battery voltage 1 activate (AUX 2)
Battery voltage 1 (AUX 2)
Battery voltage 2 activate (AUX 2)
Battery voltage 2 (AUX 2)
Battery voltage 3 activate (AUX 2)
Battery voltage 3 (AUX 2)
Battery voltage to deactivate (AUX 2)
To Next Page
Loading...
Need help?
General
