STUDER Innotec
Xtender
User manual V.3.2.0 29
6.4.3
Remote control Module RCM-10
The optional remote control module for XTM range gives the possibility to have the 2 following
function:
Main ON/OFF (1) see chap.7.1 below.
This operation can only be controlled by a potential free contact.
Command entry (7) see chap. 6.2.12 – p. 25.
This module can be plugged on DIN rail Article n°: RCM-10
Supplied with a 5m cable (max. length 5m).
Dimensions: 45 x 78mmH
Height on rail: 40mm
It is also possible to access to these functions
by a direct cabling on the RCM-10 plug of the
device (15) as per the opposite pictures.
Figure a : function input by dry contact as per
chap. 6.2.12– p.25.
Figure b : function input by a voltage as per
chap. 6.2.12– p.25.
The main on/off (1) can only be controlled by
a potential free contact.
7 CONTROL
7.1 MAIN ON/OFF CONTROL
This switch (1) interrupts the electronic supply and all the Xtender peripherals. The residual
consumption on the battery is therefore less than 1 mA.
The ON/OFF switch is used only for the complete stoppage of the whole system. This switch is not
available in the XTM. The function can be added with the use of the remote command modul
RCM-10.
To Next Page
Loading...
