Studer Xtender Series - Page 50

50 pages

Save Page as PDF

To Previous Page

STUDER Innotec

Rue des Casernes 57

1950 Sion – Switzerland

Tél : +41(0) 27 205 60 80

Fax : +41(0) 27 205 60 88

info@studer-innotec.com

www.studer-innotec.com

Main Page

Table of Contents3
Introduction5
General Information5
Operating Instructions5
Conventions6
Quality and Warranty6
Exclusion of Warranty6
Exclusion of Liability7
Warnings and Notes7
General7
Precautions for Using the Batteries8
Assembly and Installation8
Handling and Moving8
Storage8
Unpacking8
Installation Site8
Fastening9
Fastening XTH Model9
Fastening XTM Model9
Connections9
General Recommendations9
Device Connection Compartment11
Cabling12
Choice of System13
Hybrid Type Stand-Alone Systems13
Grid-Connected Emergency Systems13
Integrated Mobile Systems13
Multi-Unit Systems13
Earthing System13
Mobile Installation or Installation Connected to the Grid Via Plug Connector14
Stationary Installation14
Installation with Automatic PE-Neutral Switching14
Recommendations for Dimensioning the System15
Dimensioning the Battery15
Dimensioning the Inverter15
Dimensioning the Generator15
Dimensioning the Renewable Energy Sources15
Wiring Diagrams16
Connecting the Battery16
Battery Cable Cross-Section and DC Protective Devices16
Connecting the Battery (Xtender Side)17
Fuse Mounting on Battery Positive Pole (XTM Only)17
Battery-Side Connection17
Earthing the Battery18
Connecting the Consumers at the 230 V AC Output18
Connecting the AC Supply Sources19
Wiring Auxiliary Contacts19
Connecting the Communications Cables19
Connecting the Temperature Sensor (BTS-01)19
Connecting the Remote Command Module RCM10 (XTM Only)20
Powering up the Installation20
Description and Functioning21
Circuit Diagram21
Description of the Main Functions22
Inverter22
Automatic Load Detection22
Transfer Relay22
Battery Charger23
Limiting the Input Current by Limiting the Charger Current24
The Inverter as Source Backup ("Smart Boost" Function)25
Input Current Controlled by Input Voltage26
Battery Protection26
Xtender Protection26
Auxiliary Contacts26
The Real Time Clock27
Entry Command (Remote Control On/Off)27
Multi-Unit Configurations27
Three-Phase System28
Increasing the Power by Paralleling Units28
Combined System29
Accessories29
Control Centre and Display RCC-02/03 (Remote Control)29
BTS-01 Temperature Sensor30
Remote Control Module RCM-1031
Control31
Main On/Off Control31
Display and Control Panel32
Maintenance of the Installation34
Product Recycling34
Ec Declaration of Conformity35
Comments of Appendix Drawings36
Drawing's Elements (DC Part)38
Elements of Connect Cabinet (Fig 4A)40
Control and Display Parts for the Xtender (Fig. 4B)41
Model Identification (Fig. 1B)42
Table of Standard Configurations43
Technical Data - Xth45
Technical Data - Xtm47
Notes49

Studer Xtender Series - Page 50

Table of Contents

Related product manuals