Stulz Compact CWE - APPENDIX A - FORMS; Completed Installation Checklist

(Mar, 2012)
Compact CWE Series Installation, Operation & Maintenance Manual
A
ir Technology Systems, Inc.
APPENDIX A - FORMS
Stulz Air Technology Systems Inc.
Frederick, Maryland USA 21704
Telephone: (301) 620-2033 Facsimile: (301) 620-1396
Checklist for Completed Installation
1572 Tilco Drive, Frederick, Maryland USA 21704
Telephone: (301) 620-2033
Facsimile: (301) 620-1396
 1 Proper clearances for service access have
been maintained around equipment
 2 Equipment is level and mounting fasteners (if
applicable) are tight
 3 Piping completed to refrigerant or coolant loop
(if required)
 4 All fi eld installed piping leak tested
 5 Refrigerant charge added (if required)
 6 Condensate pump installed (if required)
 7 Condensate drain line connected & trap fi lled
with water
 8 Water supply line connected to humidifi er
(If required). If shut-off valve is installed, open
valve.
 9 Safety pan installed under ceiling mounted
equipment (if required)
 10 Filter(s) installed (if required)
 11 Ductwork completed or optional plenum
installed (if required)
 12 Incoming line voltage matches equipment
nominal nameplated rating ± tolerances
 13 Main power wiring connections to the
equipment, including earth ground, have been
properly installed
 14 Customer supplied main power circuit breaker
(HACR type) or fuses have proper ratings for
equipment installed
 15 All wiring connections are tight
 16 Control wiring connections completed to op-
tional equipment and devices including wiring
to wall mounted control panel, (if required)
 17 Foreign materials have been removed from
inside and around all installed equipment
(shipping materials, construction materials,
tools, etc.)
 18 Inspect all piping connections for leaks during
initial operation
A-1
A
ir Technology Systems, Inc.