Stulz S-Klima C7000

To Next Page

To Previous Page

Pin Designation EC Tower 2

1 Din 12

2 Din 13

3 Din 14

4 Din 15

5 Din 16

6 Din 17

7 Din 18

8 Din 19

9 Dout 8 (NO)

10 Dout 8 (COM)

11 Dout 8 (NC)

12 Dout 9 (NO)

13 Dout 9 (COM)

14 Dout 9 (NC)

15 Dout 10 (NO)

16 Dout 10 (COM)

17 Dout 10 (NC)

18 Dout 11 (NO)

19 Dout 11 (COM)

20 Dout 11 (NC)

21 Dout 12 (NO)

22 Dout 12 (COM)

23 Dout 12 (NC)

24 Dout 13 (NO)

25 Dout 13 (COM)

26 Dout 13 (NC)

27 PWM1

free

28 GND

29 PWM2

E-reheat 1 (proportional)

30 GND

X10 SUB-D 15

Pins 31 to 40 are not assigned.

The assignment depends on the unit version (DX1, DX2, CW, EC Tower 2). Explanation see page 7.

If several EDIO boards exist, the EDIO board on the lowest socket is detected as the first EDIO board and the in- and outputs are

assigned correspondingly when using the "loaddefault" command. The IOC board features four sockets for this purpose: X10, X11,

X12 and X13. X10 represents the lowest socket.

BA C7000 for EC Tower | EN | 01-2019 | 1000755

Assignment - EDIO

Stulz S-Klima C7000 - Page 9