47
BA C7000 for EC Tower | EN | 01-2019 | 1000755
Config
8. Special operating modes
Values
Week program
The week program is based on two different temperature setpoints that you have already
set in the Operate/Values/Air/Temperature menu. Setpoint 1 is represented by a “1”,
setpoint 2 by a “2”.
The setting is designed in a user-friendly way. Each digit represents an hour of the day.
The week day is represented by the line. Using the selector button you can move for-
ward and backward between the hours of the day. When you get to the end of a line, the
cursor jumps to the beginning of the next line.
Using the OK button you can change the value of the position where the cursor is. There
are three values that can be used: 0, 1 and 2. By pressing the OK button, these values
appear in ascending order and then begin at “0” again.
By pressing the button combination selector button + OK button, the value where
the cursor is placed is copied to the next position (according to the direction chosen
by the selector button). This means that several hours or days can be adjusted quickly.
You can choose between three settings for each hour of each weekday:
Display:
1. Unit off 0
2. Unit on with setpoint 1 1
3. Unit on with setpoint 2 2
Display in the main menu when execut-
ing the week program:
8.1 Week program
To Next Page
Loading...
