Stulz UltraWater 120 basic - Connecting the Water Supply (A)

STULZ UltraWater 3-stage reverse osmosis system SUW Installation
© STULZ GmbH, Hamburg
-
27
-
1
Connect the supplied 3/4" untreated water con-
nection to a cold water tap.
Warning: The untreated water connection may be
damaged if overtightened.
2
Connect the hose (black) to the untreated water
connection and connection (A) of the SUW.
The hose is available as an accessory (1220947).
3
To disassemble, squeeze the clamping sleeve and
pull off the hose.
7.2.4. Connecting the water supply (A)
To connect the supplied pressure hoses, cut the ends of the hoses straight using a sharp pipe cutter.
The components of the supplied connection material are as follows:
• Connecting hose 6 mm (black) • 3/4" untreated water connection
-
8
-
© STULZ GmbH, Hamburg
-
8
-
1.3 Lieferumfang
Wasserhahn
12 Liter Wasserspeicher
Gehäuseschüssel
Ventil
Zuleitung
Drainageanschluss /
Abflussventil Brauchwasser
Wasseranschlussadapter
Kugelventil
Wasserspeicher
UV-RöhreVerbindungsschlauch
Proceed as follows to connect the water supply:
Hose
Hose
Clamping sleeve
Untreated
water con-
nection
Note:
Take the necessary precautions at the
installation site for all other connections.
Note:
During installation, the reverse osmosis system must be separated from the drinking wa-
ter mains by a backow preventer.