Stulz UltraWater 120 basic - Personnel Qualification; Danger if Safety Instructions Are Not Complied With; Safe Working; Safety Instructions for the Plant Owner;Operator

Safety instructions STULZ UltraWater 3-stage reverse osmosis system SUW
© STULZ GmbH, Hamburg
-
8
-
2.4. Personnel qualication
All electrotechnical work must be performed exclusively by authorized and trained specialist personnel.
Specialist personnel within the context of this documentation are persons who are familiar with the electrical
installation, start-up, maintenance and repair of the system, and are in possession of the following qualica-
tions:
• Successful, certied completion of training in electrical engineering
• Familiarity with the technical documentation.
All work in relation to operation and use must be performed exclusively by authorized and trained specialist
personnel. Specialist personnel within the context of this documentation are persons who are familiar with
the operation and use of the system, and are in possession of the following qualications:
• Successful, certied completion of training in electrical engineering
• Familiarity with the technical documentation.
All work in relation to transport and storage must be performed exclusively by persons who have received
appropriate instruction.
The plant operator must ensure that all maintenance, inspection and installation work is carried out by
authorized and qualied specialist personnel who have been briefed by thoroughly studying the technical
documentation.
2.5. Danger if safety instructions are not complied with
Non-compliance with these safety instructions can result in danger to persons, to the environment and to
the system. Failure to comply with the safety instructions may result in the loss of any claims for damages.
Non-compliance may involve the following risks, for example:
- Failure of important system functions
- Failure of prescribed maintenance and repair methods
- Risk to persons due to electrical, chemical and mechanical phenomena.
2.6. Safe working
The safety instructions set out in this Technical Manual, the applicable national health and safety regulations
and any company work, operating and safety instructions must be observed.
2.7. Safety instructions for the plant owner / operator
If protection against accidental contact with moving parts is installed, it must not be removed while the sys-
tem is in operation. Dangers arising from electrical energy must be excluded (details on this can be found in
the specications of the VDE, for example, or obtained from local energy supply companies).