Stulz UltraWater 120 basic - Tightening the Filter Housing

STULZ UltraWater 3-stage reverse osmosis system SUW Installation
© STULZ GmbH, Hamburg
-
29
-
1
Tighten the lter housing rmly by hand.
7.4. Tightening the lter housing
Use the supplied housing key (to open the housing):
Proceed as follows to tighten the lter housing:
If it is not inspected monthly and tightened by hand, the lter housing
may leak!
6
Carefully close the module housing once more
(use the key).
7
Put the hose connection back together.
8
Press the complete module housing back into the
retaining clips.
P R O
U R E
I N G
W A T E R S Y S T E M