12 | Sub-Zero Customer Care 800.222.7820
Placement
CAUTION
Before moving the unit into position, secure door(s)
closed and protect any finished flooring.
Use an appliance dolly to move the unit near the opening.
If the unit has been on its back or side, it must stand
upright for a minimum of 24 hours before connecting
power.
Plug the power cord into the grounded outlet and roll the
unit into position. Verify the anti-tip brackets are properly
engaged.
IMPORTANT NOTE: If used, the side panels must be
installed before the unit is placed in its final position. Refer
to page 15.
Water Line
Approximately 3' (.9 m) of ⁄" plastic tubing is connected
to the unit with a preassembled ⁄" compression connec-
tion under the unit. The water line fitting connection kit,
provided with the unit, contains a ⁄" compression union
fitting for connection to the household water line.
Purge the water line prior to final connection to the unit.
This will remove any debris that may be present in the
tubing from installing the new water line.
Place the sleeve and nut on the water line and fasten to the
connection at the end of the tubing. Do not over tighten.
Check all water line fittings for leaks. Verify the drain pan
can be installed and removed without interference with the
water line.
IMPORTANT NOTE: If a reverse osmosis system is used, it
is recommended the water filtration system be bypassed
by removing the filter.
IMPORTANT NOTE: Water lines cannot be exposed to
freezing temperatures.
WARNING
Connect to potable water supply only.
Site Preparation
To Next Page
Loading...
Need help?
General
