Sub-Zero Classic Series User Manual

Sub-Zero Classic Series

56 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Classic Series Refrigeration

Installation Guide

SPECIFICATIONS, INSTALLATION,

AND MORE

Other manuals for Sub-Zero Classic Series

Installation Guide72 pages

Use And Care Guide100 pages

Questions and Answers:

J
joseph12Jul 29, 2025
Why is my Sub-Zero Refrigerator running hot?
- J
  jgreenJul 29, 2025
  To address high temperatures, excessive running, or excessive heat from your Sub-Zero Refrigerator: * Ensure the condenser is clean. * Confirm the door is closing correctly and hasn't been left open. * Be aware that higher room temperatures can cause the compressors to run longer. If the temperature display shows 38° and 0°, but it's not cooling, the unit might be in Showroom Mode, in which case, contact Sub-Zero Factory Certified Service.
R
Rachel HooverAug 4, 2025
How to fix a Sub-Zero Classic with no lights or cooling?
- A
  ann22Aug 4, 2025
  If your Sub-Zero Refrigerator isn't providing lights or cooling, start by verifying that the power is on and check the home circuit breaker.
E
Erica BrownAug 10, 2025
What to do if I see frost inside my Sub-Zero Refrigerator?
- B
  Benjamin BryantAug 10, 2025
  To resolve frost, condensation, or ice buildup inside your Sub-Zero Refrigerator: * Make sure the condenser is clean. * Ensure the door is closing properly and hasn't been left ajar. If heavy icing is the issue, turn off the unit and carefully melt the ice using a hairdryer set on low, keeping it moving. Wipe up any water afterward. If the door gasket has rips or tears, contact Sub-Zero Factory Certified Service.
R
Rick DavidsonAug 15, 2025
What to do if there are no lights in my Sub-Zero Classic?
- M
  Michael HoweAug 15, 2025
  If the lights are out in your Sub-Zero Refrigerator or freezer, close the door for one hour. If the lights remain off, contact Sub-Zero Factory Certified Service because the LED interior lighting must be replaced by them.

Sub-Zero Classic Series Specifications

General

Series	Classic Series
Brand	Sub-Zero
Refrigeration Type	Dual Refrigeration
Lighting	LED
Defrost System	Automatic
Air Purification	Yes
Finish	Stainless Steel
Energy Star Certified	Yes
Width	36 inches
Height	84 inches
Configuration	Side-by-Side
Preservation System	Air Purification
Ice Maker	Yes
Door Finish	Stainless Steel

Summary

Product Information

Opening Dimensions

STANDARD INSTALLATION

Details critical dimensions for standard appliance installation in cabinetry.

Opening Dimensions

FLUSH INSET INSTALLATION

Specifies crucial dimensions for flush inset appliance installations.

Opening Dimensions

DUAL STANDARD INSTALLATION

Provides opening width requirements for dual standard unit installations.

Opening Dimensions

DUAL FLUSH INSET INSTALLATION

Outlines opening width for dual flush inset appliance installations.

Dual Installation

Dual installation

Explains when dual installation kits are needed for side-by-side units.

Electrical Requirements

Plumbing Requirements

Preparation

Anti-Tip Bracket

WOOD FLOOR APPLICATION

Instructions for securing anti-tip brackets to wood flooring.

CONCRETE FLOOR APPLICATION

Details installing anti-tip brackets on concrete floors using anchors.

Anti-Tip Bracket

CONCRETE WEDGE ANCHOR INSTALLATION

Step-by-step guide for installing wedge anchors in concrete for safety brackets.

Placement

Water Line

Panel Installation

Custom Panels

Covers installation of custom door and grille panels for a proper fit.

EXTERNAL DISPENSER

Instructions for removing the dispenser bezel for custom panel installation.

Panel Installation

DOOR PANELS

Detailed steps for installing custom door panels, including trim.

Panel Installation

GRILLE PANEL

Instructions for removing and installing the bottom grille frame with a custom panel.

SIDE PANEL

Details for installing custom side panels, including kits and routing.

Alignment

LEVELING

Guide for adjusting the unit's front and rear leveling legs for proper positioning.

DOOR ADJUSTMENT

Explains how to adjust doors for side-by-side and over-and-under models.

Alignment

DOOR ADJUSTMENT

Detailed methods for adjusting door alignment: in-out, tilt, up-down, and handle sides.

Grille Installation

Instructions for installing the grille, ensuring proper fit and alignment with doors.

Completion

ANCHORING

Instructions for anchoring the unit to prevent tipping, using top and bottom methods.

KICKPLATE INSTALLATION

Steps for installing the kickplate, including alignment with brackets and panel.

Completion

WATER FILTER BYPASS

Procedures for bypassing the water filter, including removal of the cartridge.

90° DOOR STOP

Information on door stop kits that limit door opening to 90 degrees.

Related product manuals

Sub-Zero 601R/S

Sub-Zero 601F/S

Preview: Sub-Zero BI-36U/S/TH

Sub-Zero BI-36U/S/TH

Preview: Sub-Zero CBBI-36R

Sub-Zero CBBI-36R

Sub-Zero CBIC-18FI

Preview: Sub-Zero 700BR

Sub-Zero BI-48S

Sub-Zero 600 Series