Sub-Zero Classic Series User Manual

16 | Sub-Zero Customer Care 800.222.7820
Alignment
LEVELING
Once the unit is in position, turn the front leveling legs
clockwise to adjust the height. The rear height adjustment
can be made from the front of the roller base. Using a ⁄"
socket, turn the ⁄" hex bolt clockwise to raise the unit or
counterclockwise to lower. Use the lowest torque setting
when using a power drill. Do not turn the rear leveling legs
by hand. Refer to the illustration below.
When the unit is properly leveled, door and drawer adjust-
ments are less likely to be necessary.
IMPORTANT NOTE: Level the unit to the floor, not the sur-
rounding cabinetry. This could aect the operation of the
unit, such as door closing.
WARNING
To reduce the possibility of the unit tipping forward,
the front leveling legs must be in contact with the
floor.
DOOR ADJUSTMENT
Side-by-side and over-and-under doors are adjustable in
and out, and side to side tilt. Side-by-side doors only are
adjustable up and down and the handle sides are adjust-
able in and out. To adjust the handle side, rotate the
adjustable door bumper. Refer to the illustration below.
FRONT
LEVELING LEG
REAR
ADJUSTMENT
Leveling
Installation
ADJUSTABLE
DOOR BUMPER
Adjustable door bumper

Sub-Zero Classic Series Specifications

General

Series	Classic Series
Brand	Sub-Zero
Refrigeration Type	Dual Refrigeration
Lighting	LED
Defrost System	Automatic
Air Purification	Yes
Finish	Stainless Steel
Energy Star Certified	Yes
Width	36 inches
Height	84 inches
Configuration	Side-by-Side
Preservation System	Air Purification
Ice Maker	Yes
Door Finish	Stainless Steel