EasyManua.ls Logo

Subaru 2000 Legacy - ABS Warning Light; AT OIL Temperature Warning Light (for at Vehicles)

Subaru 2000 Legacy
413 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Legacy U.S.A. (66L) A2260BEB
3
Instruments and controls
3-13
CONTINUED
the proper level but the light remains on, contact your nearest SUBARU
dealer immediately.
J AT OIL TEMPerature warning light
(for AT vehicles)
If this light comes on when the engine is running, it may indicate that the
automatic transmission fluid temperature is too hot.
If the light comes on while driving, it is unnecessary to stop the vehicle,
but avoid driving up steep grades or in stop and go traffic.
B Automatic transmission control system warning
If the light flashes after the engine starts, it may indicate that the auto-
matic transmission control system is not working properly. Contact
your nearest SUBARU dealer for service immediately.
J ABS warning light
The ABS warning light comes on when the ignition switch is turned to the
ON position and goes out after about two seconds.
This is an indication that the ABS system is working properly.
If the warning light behaves as follows, the ABS system may not work
properly.
D The warning light does not come on when the ignition switch is turned
to the ON position.
D The warning light comes on when the ignition switch is turned to the
ON position, but it does not go out even when the vehicle speed
exceeds approximately 8 mph (12 km/h).
D The warning light comes on during driving.
When the warning light is on, the ABS function shuts down; however, the
conventional brake system continues to operate normally. If this occurs,
have the ABS system repaired at the first available opportunity by your
SUBARU dealer.
(U.S.)
(Canada)

Table of Contents