Instruments and controls/Multi function display
6. Select “Set” by operating the “ ”
switch, and confirm the setting by pushing
the
button.
7. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
! Approaching time setting
The setting procedure is the same as
“Leaving time setting” F3-89, but select
the “Approaching time set” item in step 3.
& Initialize
Items that have been set to your pre-
ference can be initialized. To select an
initialization menu, operate the “
” or “ ”
switch as follows.
! Preparation for initialization
1. Turn the ignition switch to the “ON”
position.
2. Push and hold the
button to show
the selection screen.
3. After the selection screen is displayed,
operate the “
” or “ ” switch to show the
“Initialize” item. Then, push the
button.
! Reset to factory default settings
1. Perform the preparation steps accord-
ing to “Preparation for initialization” F3-
90.
3-90
To Next Page
