SOUND
To change the sound settings, press the “Home” button and select “Settings”, then
“Sound”. Choose the setting you want to change.
SETTING FUNCTION
Audio In the audio settings, you may have the following setting
capabilities:
• Sound Customization —
This function allows you to set
the Equalizer, Balance/Fader and Vocal Image Control.
• Equalizer — How good an audio program sounds is
largely determined by the mix of the treble, mid and
bass levels. In fact, different kinds of music and
vocal programs usually sound better with different
mixes of treble, mid and bass.
•
Balance/Fader — A good balance of the left and
right stereo channels and of the front and rear
sound levels is also important.
Keep in mind that when listening to a stereo
recording or broadcast, changing the right/left
balance will increase the volume of 1 group of
sounds while decreasing the volume of another.
•
Vocal Image Control — Extracts only vocal sound
from whole sound and adjusts volume balance off
vocals only.
•
Sound Restorer — This function plays compressed
audio with quality near original sound by adding the
complement signal of high tone.
•
Virtual Bass — This function corrects the bass sound
by adding harmonic sound.
•
Dynamic Beat Enhancer — This function expands the
dynamic range lost in data compression and creates a
sharp beat sound.
•
Speed Volume Control — The system adjusts to the
optimum volume and tone quality according to vehicle
speed to compensate for increased vehicle noise.
• AUX Volume Gain — Sets the AUX volume gain.
Navigation Guidance Volume
Sets the navigation prompt volume.
Notification Volume Sets the interrupt guidance volume.
Beep Sound Setting Turns the tone sound on or off.
Beep Sound Volume Sets the tone sound volume.
Phone Ringtone Volume Sets the ringtone volume.
Incoming Call Volume Sets the volume of the received call.
Call Volume Sets the call volume.
SETTINGS AND UPDATES
109
To Next Page