6 Open the rear gate using the
Power Rear Gate Button.
Pause the rear gate when it
reaches the desired height
by pressing the Power
Rear Gate Button on the
instrument panel, rear gate,
or access key fob.
7 You can make gentle
adjustments to the gate
position by hand. With the
rear gate at the desired
height, press and hold the
Power Rear Gate Close
Button on the inside edge of
the rear gate. A chirp sounds
and the hazard warning
lights flash to confirm the
height is set. The Power
Rear Gate memory is
automatically saved and
enabled in the Center
Information Display (CID).
When “Power Rear Gate Memory” is enabled in the Center Information Display (CID), the rear
gate will stop at the set memory height when you use any of the Power Rear Gate buttons.
NOTE: To adjust the memory height, perform the procedure again.
6
7
HOW TO APPENDIX
145
To Next Page
Loading...
