Power Driver’s Seat (if equipped)
1 Seat Position:
Moving the
switch forward or backward
will adjust the seat in that
direction. Pulling up or
pushing down on the back of
the switch will adjust the seat
height up or down. Pulling up
or pushing down on the front
of the switch will adjust the
angle of the seat cushion.
2 Recline Seatback: Moving
the top of the switch forward
or backward will adjust the
angle of the seatback.
3 Lumbar Support:
Press the
front side of the switch to
increase lower back support.
Press the rear side of the
switch to decrease support.
If equipped, press the upper or
lower side of the switch to
adjust the lumbar support
height.
4 Thigh Extension
(if equipped): Pull up on the
lever below the seat cushion
to adjust the length.
If equipped, your Subaru can
be programmed to automatically
recall your preferred Power Driver’s
Seat and exterior mirror positions.
For step by step instructions on
setting the Power Memory Seat,
please refer to page
146 in this
Getting Started Guide.
Power Seat Controls
Thigh Extension
Memory Seat Buttons
GETTING COMFORTABLE
25