北米Model "A1760BE-A" EDITED: 2020/ 10/ 1
in a neighboring lane or approach-
ing from either side.
The driver is responsible for paying
attention to the rear and side areas
of the vehicle.
& System features
S07BM01
BSD/RCTA consists of the following func-
tions.
. To detect a vehicle in a blind spot on an
adjacent lane or a vehicle approaching at
high speed while driving the vehicle (Blind
Spot Detection)
. To detect a vehicle approaching from
the right or left while reversing the vehicle
(Rear Cross Traffic Alert)
The system uses radar sensors for the
following features.
NOTE
The BSD/RCTA radar sensor has been
certified by the radio wave related laws
of the U.S., Canada and Mexico. When
driving in other countries, certification
of the country where the vehicle is
driven must be obtained. For certifica-
tion in the U.S., Canada and Mexico,
refer to “Certification for the BSD/
RCTA” F7-63.
! Blind Spot Detection (BSD)
S07BM0101
1) Operating range
The system warns the driver of dangers as
follows.
. If the system detects vehicles in the
driver’s blind spots, the BSD/RCTA ap-
proach indicator light(s) on the outside
mirror(s) will illuminate.
. If the driver operates the turn signal
lever to the side where the BSD/RCTA
approach indicator light is illuminated, the
corresponding BSD/RCTA approach indi-
cator light will flash.
! Lane Change Assist (LCA)
S07BM010101
1) Operating range
The system warns the driver of dangers as
follows.
. If the system detects vehicles ap-
proaching at high speeds in the neighbor-
ing lanes, the BSD/RCTA approach indi-
cator light(s) on the outside mirror(s) will
illuminate.
. If the driver operates the turn signal
lever to the side where the BSD/RCTA
approach indicator light is illuminated, the
corresponding BSD/RCTA approach indi-
cator light will flash.
– CONTINUED –
Starting and operating/BSD/RCTA
7-57
7
To Next Page
Loading...
Need help?
General
