北米Model "A1760BE-A" EDITED: 2020/ 10/ 1
cancel the system, refer to “Cancel-
ing the Reverse Automatic Braking
(RAB) system operation” F7-74.
& Operating conditions
S07BN02
The Reverse Automatic Braking (RAB)
system will operate when all of the follow-
ing conditions are met.
1) EyeSight warning indicator
2) RAB warning indicator
3) RAB OFF indicator
. The ignition switch is in the “ON”
position.
. The EyeSight warning indicator is off.
. The RAB warning indicator is off.
. The RAB OFF indicator is off.
. The Reverse Automatic Braking (RAB)
system is set to on.
. The select lever is in the “R” position.
. The vehicle speed is between 1 to 9
mph (1.5 to 15 km/h).
NOTE
. When the RAB warning indicator is
illuminated, the Reverse Automatic
Braking (RAB) system cannot be oper-
ated. Promptly contact a SUBARU deal-
er to have the system inspected.
. When the RAB OFF indicator is
illuminated, the Reverse Automatic
Braking (RAB) system cannot be oper-
ated.
. In the following cases, the system
may not be able to properly detect an
obstacle. Promptly contact a SUBARU
dealer to have the system inspected.
– A sticker, paint, or a chemical is
applied to the sonar sensors or the
rear bumper near the sonar sensor.
– The rear bumper is modified.
– The rear bumper has been re-
moved and reattached.
– The ground clearance is changed
due to the vehicle’s loading condi-
tion or modification.
– Ice, snow or mud is adhered to
the sonar sensors or the rear bum-
per near the sonar sensor.
– The rear bumper is exposed to
strong impact, or the rear bumper is
deformed.
. When the 7-inch audio/navigation
system is performing a software up-
date, the Reverse Automatic Braking
(RAB) system may not display the
following items on the audio/navigation
screen until the update is complete.
– Display Icon on/off Function
– Distance Indicator Image
– Warning Message
. On a steep hill, the system’s auto-
matic braking ability will be reduced.
. The system is designed to avoid
collisions by automatic hard braking
when the vehicle’s reversing speed is
less than approximately 3 mph (5 km/h).
However, the system does not guaran-
tee that the vehicle will be able to avoid
collisions in any situation.
. If the vehicle is reversed at an
extremely slow speed, the driver’s
operation may be prioritized. In this
case, automatic braking will not oper-
ate.
. The system may not be able to detect
the following objects.
– Sharp or thin objects such as
poles, fences and ropes which may
not reflect the sound wave emitted
from the sonar sensor.
Starting and operating/Reverse Automatic Braking (RAB) system
7-68
To Next Page
Loading...
Need help?
General
