北米Model "A1760BE-A" EDITED: 2020/ 10/ 1
turn the neck of the washer fluid filler pipe
as illustrated.
Right-hand side
Right-hand side: Use a screwdriver to
undo the clips on the air intake duct, then
remove the air intake duct.
2. Remove the bulb from the headlight
assembly by turning it counterclockwise.
3. Replace the bulb with a new one. At
this time, use care not to touch the bulb
surface.
4. To install the bulb to the headlight
assembly, turn it clockwise until it clicks.
5. Left-hand side: Set the washer fluid
filler pipe to the original place and secure it
with a clip.
Right-hand side: Install the air intake duct
with clips.
& Front fog light (models with
the LED front fog light)
S11BE53
Have the front fog light assembly checked
by your SUBARU dealer.
& Front fog light (models with-
out the LED front fog light) (if
equipped)
S11BE04
NOTE
It may be difficult to replace the bulbs.
Have the bulbs replaced by your
SUBARU dealer if necessary.
1. Remove the clips.
Maintenance and service/Replacing bulbs
11-48
To Next Page
Loading...
Need help?
General
