Subsite 910R - Page 10

10 910R/950R/950T/970T - RECEIVER
CONTROLS (SINGLE KEY)
10 910R/950R/950T/970T - RECEIVER
CONTROLS (SINGLE KEY)
Down Arrow
Press to decrease manual gain incrementally
from 20% to 80%.
If signal is above 80%, press once to lower
gain (decrease signal) to approximately 50%.
To disable this feature:
1. Ensure that unit is off.
2. Press and hold the down arrow.
3. Turn unit on.
MODE
Selects operating frequency.
DEPTH
Estimates depth of signal or shows amount of
current on the target line.
• Press once to estimate depth of properly
located signal source.
• Press and hold to show amount of current
on the target line in milliamps (mA).
See OPERATION for information on locating signals.
Down Arrow
Press to decrease manual gain incrementally
from 20% to 80%.
If signal is above 80%, press once to lower
gain (decrease signal) to approximately 50%.
To disable this feature:
1. Ensure that unit is off.
2. Press and hold the down arrow.
3. Turn unit on.
MODE
Selects operating frequency.
DEPTH
Estimates depth of signal or shows amount of
current on the target line.
• Press once to estimate depth of properly
located signal source.
• Press and hold to show amount of current
on the target line in milliamps (mA).
See OPERATION for information on locating signals.