Subsite 910R - Setup

910R/950R/950T/970T - 970T TRANSMITTER 33
SETUP
910R/950R/950T/970T - 970T TRANSMITTER 33
SETUP
SETUP
Install Batteries
Use eight D-cell alkaline batteries
in transmitter.
To install:
1. Unscrew battery cover.
2. Insert batteries as shown.
3. Close and tighten battery
cover.
4. Check operation.
Check Operation
Always check that transmitter is
operating before leaving for jobsite
and after every battery change.
To check operation:
1. Turn on transmitter.
2. Transmitter will beep.
3. Display will show battery level
and last used frequency
setting.
SETUP
Install Batteries
Use eight D-cell alkaline batteries
in transmitter.
To install:
1. Unscrew battery cover.
2. Insert batteries as shown.
3. Close and tighten battery
cover.
4. Check operation.
Check Operation
Always check that transmitter is
operating before leaving for jobsite
and after every battery change.
To check operation:
1. Turn on transmitter.
2. Transmitter will beep.
3. Display will show battery level
and last used frequency
setting.