910R/950R/950T/970T - OPERATION 39
CHOOSE SIGNAL TYPE
910R/950R/950T/970T - OPERATION 39
CHOOSE SIGNAL TYPE
OPERATION
This section contains basic information about choosing signal
type and antenna configuration, avoiding and correcting common
signal problems, and three types of locating.
CHOOSE SIGNAL TYPE
The 950R can detect two types of signals:
• Active signals are placed on a target line with the transmitter
and detected by the receiver. As an option, an active signal
from a beacon can also be detected by the receiver.
• Passive signals reside on the target line and are read by
receiver.
Read the descriptions on the next page and determine the signal
type to use for your job.
OPERATION
This section contains basic information about choosing signal
type and antenna configuration, avoiding and correcting common
signal problems, and three types of locating.
CHOOSE SIGNAL TYPE
The 950R can detect two types of signals:
• Active signals are placed on a target line with the transmitter
and detected by the receiver. As an option, an active signal
from a beacon can also be detected by the receiver.
• Passive signals reside on the target line and are read by
receiver.
Read the descriptions on the next page and determine the signal
type to use for your job.
To Next Page
Loading...