• Rotate the main switch (6) (see fig.1) counter-clockwise and make sure the scooter does not start. (TURNING
OFF THE DPV);
• Fully rotate the By Pass knob (50) (see fig. above) clockwise without forcing;
• Rotate the main switch (6) clockwise. The scooter starts in continuous mode. If it does not start, the scooter is
broken. Abandon or recover it;
• Rotate the main switch (6) counter-clockwise to stop the scooter.
Turn the scooter on and off using the main switch without forcing.
In normal operating conditions, the By Pass device knob should be ALWAYS FULLY rotated counter-clockwise.
BY PASS KNOB PROTECTION
The by pass knob must be always protected with its special protection click-cap. The special protection click-cap has
to be removed only when it is necessary to activate the BY PASS SYSTEM.
Never remove the special protection click-cap for other reasons. It has always to be in place in order to protect the
by pass knob against any accidental activation. (51) (fig. above).
22. RUNNING TIME AND SPEED
Running time data is indicative and is nevertheless referred to use:
• with a SCOOTER in perfect running order;
• in moderate environments;
• in the absence of currents;
• with an average load (diver with a double tank 12+12 liters or oxygen rebreather);
• in perfect buoyancy conditions.
As a rule the running time must be calculated, an autonomy RESERVE must also be established which will vary
according to the type of dive.
In any case, the dive must be programmed taking into account that it can return to the point of emersion without the
aid of the SCOOTER.
As with autonomy, speed also depends on the same factors. The speed compatible with the type of dive must be
considered and adjusted to that of the companions.
23. BLUETOOTH CONNECTION
SUEX SCOOTERs are equipped with bluetooth devices that allow to get motor and battery information (if Li-ion
battery with Drive system has been installed).
These functions are available only out of water and require the Calypso App (available on Google Play & App store).
In order to turn the Bluetooth system on, the battery has to be connected to the motor and the SCOOTER has to be
switched ON.
In order to read the battery data when the battery is off-board, connect the battery to the charger and plug the charger
to the main. Once the Bluetooth devices are ON, the application is ready and the data can be read.
First time connection will require Bluetooth pairing of devices and smartphone.
The battery with DRIVe system will have an identifier of this type: SB_AAxxxxxxxxxxxx_BT.
The motor has a serial number such as AAxxxxxxxxxx.
From here on, follow the App instructions.
SCOOTER acceleration ramp can be adjusted by the same App.
To Next Page
Loading...
