THE USE OF PROTECTIVE GLOVES IS ALWAYS MANDATORY
The use of the hands or other parts of the body between the propeller blades is a
potentially dangerous action, despite the existence of a safety clutch between the
propeller and the engine. In the case of replacement or removal of the prop lock
propeller, always make sure that the SCOOTER is off, or by pressing the trigger,
the propeller must not turn!
HOW TO INSERT THE PROP LOCK PROPELLER
Switch off the SCOOTER and make sure it is switched off!
Insert the motor shaft of the SCOOTER (35 - Fig.10) in the hole of the propeller (36), turn the propeller (clockwise)
until the pin (33) matches the seat (34) propeller. When you hear a click, the propeller will stop turning. Continue by
turning (CLOCKWISE) the switch (6) WITH THE FINGER ONLY, WITHOUT FORCING.
FOR THE CORRECT POSITIONING AND OPERATION OF THE PROP LOCK
PROPELLER IT IS ESSENTIAL THAT THE PLUG (33) IS CORRESPONDING TO THE
SEAT (34)
28.5. MAINTENANCE PROP LOCK PROPELLER
The prop lock propeller does not require specific maintenance. However, would be appropriate make sure that
everything is clean and free from debris.
THE USE OF PROTECTIVE GLOVES IS ALWAYS MANDATORY
WHEN REMOVING AND REPLACING THE PROPELLER UNDERWATER, BE
CAREFUL NOT TO DROP IT: THE PROPLOCK PROPELLER SINKS!
To Next Page
Loading...
