SECTION 6 3000-4500 USER MANUAL
65
AIR FILTER ELEMENT REPLACEMENT
1. Clean exterior of air filter housing.
2. Rotate end cover counterclockwise and
remove
3. Remove air filter element by pulling it out of
the housing.
4. Clean interior of housing using a damp cloth.
DO NOT blow dirt out with compressed air.
5. At this time replace the element.
6. Reassemble in the reverse order of the dis-
assembly.
6.8 SEPARATOR MAINTENANCE
Replace the separator element when indicated by
the WS Controller or after one (1) year, whichever
comes first. The separator element must be
replaced. DO NOT attempt to clean the separator
element.
SEPARATOR ELEMENT REPLACEMENT
Refer to Figure 6-3. The separator element must be
changed when indicated by the WS Controller, or
once a year, whichever occurs first. Follow the
procedure explained below for separator element
replacement:
1. Loosen and remove the eight (8) hex head
capscrews (M12 x 40mm) from the cover
plate.
2. Lift the cover plate from the separator/sump
tank.
3. Remove the separator element.
4. Inspect the separator/sump tank for rust, dirt,
etc.
5. Reinsert the separator element into the sep-
arator/sump tank taking care not to dent the
element against the tank opening.
6. Install a new lubricated O-ring in the O-ring
groove on the underside of the separator/
sump tank cover.
7. Replace the cover plate, washers and cap-
screws. Torque to 49 ft·lbs. (68 N·m).
8. Clean the return line strainer before restart-
ing the compressor.
1. Cover
2. Ground Spring*
3. Spring Fastener*
4. Cover Gasket*
5. Element*
6. Separator/Sump Tank
Separator Element: P/N 02250160-774
*Separator Element Replacement Kit: P/N
02250160-776
Figure 6-3: Separator Element Assembly
NOTE
Relieve all pressure from the separator/
sump tank and all compressor lines.
To Next Page
Loading...
