Sullair 3007 - Maintenance Every 2000 Hours; Fluid Maintenance; Filter Maintenance; Fluid Filter Element Replacement

6.4 MAINTENANCE EVERY 2000
HOURS
After 2000 hours of operation, it will be necessary to
perform the following:
1. Clean the return line strainer. Refer to Discharge,
Receiver and Piping System, 3000P, 3700 and 4500
on page 96.
2. Replace the fluid filter element.
3
2
1
SA_0000017
1. Filter Head
2. Element*
3. Body
Fluid Filter Assembly: P/N 02250155-708
*Fluid Filter
Replacement Kit:
P/N 02250155-709
Figure 6-1: Fluid Filter Assembly
6.5 FLUID MAINTENANCE
Drain the receiver tank and change the compressor fluid
using instructions shown in
Lubrication Guide on page 20.
6.6 FILTER MAINTENANCE
Refer to Figure 6-1. Replace your fluid filter element under
any of the following conditions, whichever occurs first:
1. As indicated by the WS Controller.
2. Every fluid change.
Fluid Filter Element Replacement
Refer to Figure 6-1.
1. Using a wrench, remove the filter canister.
2. Remove and dispose of filter element. Observe all
laws and regulations for filter disposal.
3. Clean gasket seating surface.
4. Apply a light film of fluid to the element seal.
5. Install the element into the filter canister.
6. Screw the canister to the filter head. Tighten to 10 to
12 ft•lb (13.5 to 16.0 N·m).
7. Restart compressor and check for leaks.
6.7 AIR FILTER MAINTENANCE
1
2
3
SA_0000018
1. Housing
2. Element*
3. Cover
Air Filter Assembly: P/N 02250127-683
* Replacement Air
Filter Element Kit:
P/N 02250127-684
Figure 6-2: Air Filter Assembly
Refer to Figure 6-2. Air filter maintenance should be
performed when the maintenance gauge shows red with
the compressor running full load, or once a year,
whichever comes first. If the filter needs to be replaced,
order a replacement element. Below you will find
procedures on how to replace the air filter element.
SECTION 6
62
3000-4500 Operator’s Manual and Parts List
®SULLAIR®