Sullair 425 - Page 59

53
375 John Deere Standard and Aftercooled/Filtered Operator’s Manual and Parts List
DESCRIPTION
DTCs Listing in Ascending SPN/FMI Codes
SPN FMI Blink
Code
Description of Fault Corrective Action
000111 01 64 Engine Coolant Level Low Check Operator’s Manual “Adding
Coolant”
000158 17 54 ECU Power Down Error (internal ECU problem) Contact Servicing Dealer
000160 02 — Axle Speed Unreliable Contact Servicing Dealer
000174 00 — Fuel Temp Signal Extremely High Add Fuel or Switch Fuel Tanks
03 37 Fuel Temp Signal Out of Range High Check Sensor and Wiring
04 38 Fuel Temp Signal Out of Range Low Check Sensor and Wiring
16 71 Fuel Temp Signal Moderately High Add Fuel or Switch Fuel Tanks
000189 00 — Engine Speed Derate Condition Exists Check Fault Codes/Contact
Servicing Dealer
000190 00 42 Engine Speed Extremely High Reduce Engine Speed
16 42 Engine Speed Moderately High Reduce Engine Speed
000611 03 98 Injector Shorted to Power Check Wiring
04 99 Injector Shorted to Ground Check Wiring
000620 03 98 Sensor Supply 2 Voltage High Check Wiring
04 22 Sensor Supply 2 Voltage Low Check Wiring
000627 01 97 All Injector Currents Are Low Check Battery Voltage and Wiring
000629 13 — ECU Programming Error Contact Service Dealer
000636 02 44 Engine Position Sensor Signal Unreliable Check Sensor and Wiring
08 43 Engine Position Sensor Signal Missing Check Sensor and Wiring
10 44 Engine Position Sensor Signal Rate of Change—Abnormal Check Sensor and Wiring
000637 02 39 Engine Timing Sensor Signal Unreliable Check Sensor and Wiring
000637 07 45 Engine Position Sensor Signal Rate of Change—Abnormal Check Sensor and Wiring
08 41 Engine Timing Sensor Signal Missing Check Sensor Wiring
10 39 Engine Timing Signal Rate of Change—Abnormal Check Sensor and Wiring
000639 13 — CAN Bus Error (Communication Network Problem) Contact Servicing Dealer
000651 05 31 Injector Number 1 Circuit Has High Resistance Check Injector Wiring or Injector
Solenoid
06 91 Injector Number 1 Circuit Has Low Resistance Check Injector Wiring or Injector
Solenoid
07 65 Injector Number 1 Not Responding Injector Failed or Flow Limiter Closed
000652 05 29 Injector Number 2 Circuit Has High Resistance Check Injector Wiring or Injector
Solenoid
06 92 Injector Number 2 Circuit Has Low Resistance Check Injector Wiring or Injector
Solenoid
07 65 Injector Number 2 Not Responding Injector Failed or Flow Limiter Closed
000653 05 17 Injector Number 3 Circuit Has High Resistance Check Injector Wiring or Injector
Solenoid
06 93 Injector Number 3 Circuit Has Low Resistance Check Injector Wiring or Injector
Solenoid
07 65 Injector Number 3 Not Responding Injector Failed or Flow Limiter Closed