Sullair 425 - Lubrication Guide - Compressor; Application Guide; Lubrication Guide - Engine

60
375 John Deere Standard and Aftercooled/Filtered Operator’s Manual and Parts List
SECTION 3
LUBRICATION GUIDE – COMPRESSOR3.3
FLUID TYPE CHANGE PERIOD/HOURS AMBIENT TEMPERATURE
RANGE °F (°C)
Sullair AWF (I) 1500 -20 to 120 (-29 to 49)
SAE 10W SE, SF, SG, CD 250 0 to 100 (-18 to 38)
MIL-L-2104E 10W 250 0 to 100 (-18 to 38)
(I) Sullair part numbers for Sullair AWF are 250030-757 (5 gallons/18.9 liters) and 250030-758 (55 gallon drum/208 liters).
APPLICATION GUIDE3.4
Sullair air compressors are supplied with Sullair AWF
which is a heavy duty multi-viscosity, all weather uid
which provides an extended change interval when
compared to other uids. Detergent motor oils (SAE 10W
Class SE, SF, SG, or CD) can also be used. Any of these
oils are suitable under conditions where severe oil
oxidation can occur.
Water must be drained from the receiver tank periodically.
In high ambient temperature and humidity conditions,
condensed moisture can emulsify with the oil forming a
“milky” color. SAE 10W is especially prone to this
condition. The uid should be changed if this condition
develops. DO NOT mix different uids. Combinations of
different uids can lead to operational problems such as
foaming, plugged lters, blocked orices or lines.
When ambient conditions exceed the recommended
ranges, or if other conditions warrant the use of other
extended life lubricants, contact your local Sullair
representative for recommendations.
Sullair encourages users to participate in a uid analysis
program. The analysis might indicate a need for change
intervals different from those recommended in this manual.
Sullair Corporation offers a uid analysis for Sullair AWF.
Contact Sullair for details.
D-A Lubricant® Company Inc. offers an analysis for users
of Sullair AWF. Contact your Sullair representative for
details.
LUBRICATION GUIDE – ENGINE3.5
Refer to the Engine Operator’s Manual for oil
specications.
SU_0000699
Fluid Fill Port1.
Sight Glass2.
Receiver Tank3.
Figure 3-1
NOTE
Proper Compressor Fluid Level
Visible halfway in uid sight glass
when checked on a level surface with
the compressor not running.