Sullair 425 - Noise Emission Maintenance and Maintenance Record Log; Noise Emissions Maintenance and Maintenance Record Log

74
375 John Deere Standard and Aftercooled/Filtered Operator’s Manual and Parts List
SECTION 6
NOISE EMISSIONS MAINTENANCE AND MAINTENANCE RECORD LOG6.3
Noise Emission Maintenance and Maintenance Record Log
1. ANNUAL MUFFLER AND EXHAUST SYSTEM INSPECTION
At least annually inspect mufer(s) and engine exhaust system to make sure all parts are securely mounted, that all joints and
connections are tight, and that the mufer is in good condition. DO NOT operate compressor with defective exhaust system.
Remove and replace any defective parts by ordering with part numbers indicated in the Parts List.
Maintenance Performed
By
Location
Date
Maintenance Performed
By
Location
Date
2. ANNUAL AIR FILTER(S) AND AIR INLET SYSTEM INSPECTION
In addition to the instructions in the Maintenance section of the Operator’s Manual, the air lter(s) and entire air inlet system should
be inspected at least annually, to make sure all parts are securely mounted, that all joints and connections are tight, that there are no
other leaks in the system, and that the lter element(s) are intact. DO NOT operate compressor with defective air inlet system.
Remove and replace defective parts by ordering with part numbers indicated in the Parts List.
Maintenance Performed
By
Location
Date
Maintenance Performed
By
Location
Date
The following instructions and maintenance record log
book, for the proper maintenance, use and repair of this
compressor, is intended to prevent noise emission
degradation.