Sullair TS-32 - (200, 250 and 300 HP;150, 187 and 225 KW); (400, 500 and 600 HP;300, 375 and 450 KW)

TABLE OF CONTENTS
(CONTINUED)
Section 5
PAGE
DESCRIPTION 17 5.1 INTRODUCTION
17
5.2 DESCRIPTION OF COMPONENTS
18
5.3 SULLAIR COMPRESSOR UNIT, FUNCTIONAL DESCRIPTION
18
5.4 COMPRESSOR COOLING AND LUBRICATION SYSTEM,
FUNCTIONAL DESCRIPTION
18
5.5 COMPRESSOR DISCHARGE SYSTEM, FUNCTIONAL
DESCRIPTION (200, 250 and 300HP/150, 187 AND 225KW)
20
5.6 COMPRESSOR DISCHARGE SYSTEM, FUNCTIONAL
DESCRIPTION (400, 500 AND 600HP/300, 375 AND 450K W)
24
5.7 CONTROL SYSTEM, FUNCTIONAL DESCRIPTION
30
5.8 AIR INLET SYSTEM, FUNCTIONAL DESCRIPTION
Section 6
COMPRESSOR OPERATION
31 6.1 GENERAL
31 6.2 PURPOSE OF CONTROLS
33 6.3 INITIAL START---UP PROCEDURE
34
6.4 SUBSEQUENT START---UP PROCEDURE
34 6.5 SHUTDOWN PROCEDURE
Section 7
MAINTENANCE 35 7.1 GENERAL
35 7.2 DAILY OPERATION
35
7.3 MAINTENANCE AFTER INITIAL 50 HOURS OF OPERATION
35 7.4 MAINTENANCE AFTER 1000 HOURS
35 7.5 FLUID CHANGE
35 7.6 SEPARATOR MAINTENANCE
35 7.7 PARTS REPLACEMENT AND ADJUSTMENT PROCEDURES
36 AIR FILTER MAINTENANCE
38 SEPARATOR ELEMENTS REPLACEMENT
38 CONTROL SYSTEM ADJUSTMENT
39 DRIVE COUPLING INSTALLATION AND A LIGNMENT
(200, 250 and 300HP/150, 187 and 225KW)
40 DRIVE COUPLING INSTALLATION AND A LIGNMENT
(400, 500 and 600HP/300, 375 and 450KW)
43 CONTROL LINE FILTER MAINTENANCE
43 MOTOR CONNECTION INSTRUCTIONS
44 7.8 TROUBLESHOOTING