lNSTALLING / REMOVING THE BASE STAND
WARNING: The LED Display is very fragile, and must be protected at all times when removing the base
Stand.
Be sure that no hard or sharp object or anything that could scratch or damage the LED display comes into
contact with it Do NOT exert pressure on the front of the unit at any time because the screen could crack
- Disconnect all cables or cords connected to the unit.
- Lay the unit down on a flat surface with the back side facing
up Please make sure to place a soft
cushioned material (such as a pillow or thick piece of foam) beneath the screen.
- To remove the base stand, loosen screws off the holes then pull downwards to release
the base stand
MOUNTING ON THE WALL
This unit is VESA-compliant, and is designed to be wall-mounted with aVESA-compliant4” x4·
(1OOmm x1OOmm) mounting kit designed for flat-panel TVs (not supplied).
Length of screw should not exceed 1O mm (not supplied).
NOTE
Remove the base stand before mounting the unit on the wall
Four mounting holes
(size M44 screw)
11
To Next Page
Loading...
