Sumitomo Beier Variator Series User Manual

23
(6) Long-term Stoppage
Stoppage Period
Approx. 1 month
More than 1 month
Change the oil and operate the unit for several minutes before stopping the unit.
Flush the unit, fill with rust-preventive oil, and operate the unit without a load for several
minutes before stopping the unit.
• Before starting operation after long-term stoppage, always change the oil. This will ensure that the lubricant is
free from deterioration that may have been caused by long-term stoppage.
Table 27 Long-Term Stoppage
8-5) Grease Replenishment and Change for CYCLO Portion
(1) Grease Replenishment/Change Interval
Model Grease supply/change interval
Long-life grease series
( section in Table 11, 12 on
page 17)
Long-life grease (BEN10-No.2) is supplied with these
models, so operation can continue for extended periods.
However, disassembly to change the grease after 20,000
hr or 3 to 5 years operation will ensure longer service life.
Grease-lubricated models other
than maintenance-free
Refer to Tables 29 and 30 for supply and change of
grease.
Table 28 Grease Supply/Change Intervals
Hours of
operation
10 hr max./day
10–24 hr/day
Replenishment
interval
3–6 months
Remarks
Reduce the supply inter-
val when the operating
conditions are severe or
the frame size is large.
Change interval
Every 20,000 hr or
3–5 years
Remarks
Reduce the supply inter-
val when the operating
conditions are severe or
the frame size is large.
500–1,000 hr
Table 29 Grease Replenishment Interval
(Excl. Long-life grease series)
Table 30 Grease Change Interval
(Excl. Long-life grease series)
(2) Recommended Grease
Table 31 Recommended Grease
This is recommended grease starting from units shipped April 1, 2006.
There is no problem for mixing with our prerious recommended grease, ALVANA Grease RA by
Shell Oil.
Ambient
temperature
(°C)
-10~50
Model
i) Long-life grease series
( section in Table 11,12 on page 17)
ii) Other grease model
Nippeco Cosmo Oil
BEN10-No.2
COSMO GREASE
DYNAMAX SH No.2
• Do not use any grease other than those shown in Table 31.
• Models ii) in Table 31 are filled with COSMO GREASE DYNAMAX SH No.2 before shipment from our factory.
• The two kinds of grease for ii) in Table 31 may be mixed with each other.
• When the ambient temperature continuously exceeds the range of 0~40°C, modifications are needed.

Sumitomo Beier Variator Series Specifications

General

Brand	Sumitomo
Model	Beier Variator Series
Category	Engine
Language	English