Installation, Operation, and Maintenance Manual
SUMMIT PUMP MODEL SP 17
Table 7
31. Install Case Bolt(12) and onto Cover Plate(9) and fully tighten nuts to ease in
assembly.
32. Put the Stuffing Box(13) on flat surface with the gland side facing upward.
33. Insert the Lantern Restrictor(14) with the small end down fitting in the center of
the Stuffing Box.
34. Place the Shaft Sleeve(15) through the center of the Lantern Restrictor(14).
35. Insert the Packing(19) into the Stuffing Box(13) fitting the Packing(19) with the
joints staggered from one to the next.
36. Join the Gland(20) halves together with the Clamp Bolts(21) tightening them
completely.
37. Install the assembled Gland(20) onto the Stuffing Box(13) with the flat side
facing away from the Stuffing Box(13) compressing the Packing(19) into the
Stuffing Box(13).
38. Install the Gland Bolt(23) to the assembly of the Stuffing Box(13) and Gland(20).
39. Place the Shaft Sleeve O-Ring(16) onto the Shaft(2.1) sliding it up to the Bearing
Labyrinth(2.6).
40. Install the assembled Stuffing Box(13) onto Frame Plate(31). Be sure to install
the Stuffing Box with the flush port facing upward.
41. Place the second Shaft Sleeve O-Ring(16) onto the Shaft(2.1) and push it into the
recess in the Shaft Sleeve(15).
42. Insert the Shaft Spacer(17) onto Shaft(2.1) and press up tightly against the Shaft
Sleeve(15).
43. Coat the shaft thread with anti-seize lubricant.
44. Place the Rear Cover Plate Gasket(26) onto the Stuffing Box(13) and Seal
Ring(28) onto the Cover Plate(9). If Cover Plate Gasket(26) or Seal Ring(28) will
not stay in place rubber cement can be used to hold them in place.
45. Install the Rear Liner Plate(27) then screw on Impeller(29).
46. Fit Liner(30) over impeller and mount against the Rear Liner Plate(27).
47. Install Frame Plate(31) onto Case Bolt(12) tighten nuts to value on Table 7 being
sure to tighten evenly in a criss-cross patern. Pump is now ready for impeller
adjustment.
To Next Page
Loading...
