Summit SP - Page 21

Installation, Operation, and Maintenance Manual
SUMMIT PUMP MODEL SP 16
Table 6
Bearing Assembly End Play
N005
.0020" - .0045"
(.050 - .110mm)
P005, CC005
.0030" - .0062"
(.074 - .159mm)
Q005, DD005
.0040" - .0065"
(.102 - .165mm)
R005, RS005, EE005
.0032" - .0060"
(.081 - .152mm)
S005, SH005, FF005
.0024" - .0070"
(.061 - .178mm)
T005, TH005, GG005
.0065" - .0090"
(.165 - .229mm)
U005
.0075" - .0122"
(.191 - .312mm)
24. Insert Heavy Hex Bolt(3) into Base(1) from exterior screw on one nut and
tighten. Next screw on one Nut(4) the two Washers(5) and the last Nut(4) leaving
them loose and as far apart as possible.
25. Grease the machined surfaces on Base(1) where Bearing Assembly(2) will sit.
26. Lower Bearing Assembly(2) onto Base(1) lining up machine surfaces of the
Bearing Housing(2.3) with the holes in the Base(1). Be sure that the Bearing
Housing(2.3) adjustment lug fits in between the two washer(5) on the Heavy Hex
Bolt(3) adjuster.
27. Insert the clamp bolt Heavy Hex Bolt(6) and Plain Washer(7) into Base(1) and
install Plain Washer(7) and Nut(4) from top. Fully tighten “ALPHA” side bolts
leaving “BETA” side bolts finger tight. (See Fig 5.)
"BETA" SIDE BOLTS
"ALPHA" SIDE BOLTS
Fig 5.
28. Grease Shaft(2.1) on impeller end to help in installing shaft components and
prevent rusting.
29. Mount the Cover Plate(9) to Base(1) with three Case-Frame Bolt(10) and Hex
Nut(11). Be sure that the shoulder of the Cover Plate is fit into the recess in the
Base.
30. Torque the Case-Frame Bolt(10) Hex Nut(11) to the values on Table 7,