28 | P a g e
To adjust the lid, loosen the locking nuts
(highlighted in the cross section) on the
underside of the threaded pivots. The
uppermost nut then can be adjusted up or
down to achieve the appropriate seal required
for the system to work properly. It is important
to tighten the locking nuts after the
appropriate setting is achieved. When
adjusting the hinge, it is equally important to
adjust the catch in the same manner to create a consistent seal all around the
rim. This can be done be loosening the locking nut and adjusting the catch up or
down in the same way as the hinge. Always remember to tighten the locking nut
once complete.
5.2 Adjustments
Always ensure you wear the correct PPE as described previously, before attempting to
make any of the following adjustments, and watch out for any finger traps/potential
crushing.
5.2.1 Chassis Height / Parallelism (Trailed Machines Only)
Chassis height can only be adjusted via the tractor/ hitch point, simply by
unbolting the hitch eye and raising it, then re-bolting it to the chassis. Note: the
chassis should always be parallel to the ground. Torque Value = 600Nm.
5.2.2 Isocan Artemis – Seed Drill Controller
The isocan Artemis system is design to allow automatic, Variable rate control of
any drill. You can at any time manually override the predetermined rate as field
conditions require.
• The basic functions are:
• Variable Rate Control
• Tramline Control
• Forward speed alarms
• Hopper level alarm
• Fan speed & alarm
To Next Page
Loading...
