30 Sun Fire X4150 Server Product Notes • February 2010
IPMITool 1.8.9.4 or Later Needed to Correctly Display
Memory Errors
ipmitool 1.8.9.4 can be obtained from utilities/ipmitool directory from
Tools and Drivers CD.
The Sun Splash Screen in the Serial Console Does Not
Display
When booting the system with the console output directed to the serial port, the Sun
splash screen will not appear and you will not see the prompt to press F2 to enter
the BIOS Setup utility. Use the following procedure to disable the Sun splash screen:
▼ Disabling the Sun Splash Screen
1. Press the F2 key to enter the BIOS Setup Utility.
2. Select Boot -> Boot Setting Configuration.
3. Set the boot setting to quiet boot - disable.
This will enable a prompt to press F2.
SP Settings Might Revert to Factory Defaults After an
Unsaved Update from the Web GUI or CLI
When updating the SP from the server management web GUI or CLI, be sure to use
the SaveFlag (CLI) or Save Configuration (web GUI) commands to save the updated
information. If not, the factory default settings will be used instead. For example, if
static IP addressing is configured for the SP and a future update to the SP
configurations was not saved, the SP may revert to the default of DHCP addressing.
Minimum Supported Version for a Remote Sparc System
When running the web GUI from a Sparc-based system, Solaris 10 OS is the
minimum version that is supported.
To Next Page
Loading...
