14 Sun Fire X4150 Server Product Notes • February 2010
Critical Issues
Serial Console ttya/ttyb for Preinstalled Solaris
Has Changed
The serial console settings for Solaris preinstalled distributions has changed for the
release of the Tools and Drivers 1.3.1 CD and beyond.
Make the following changes in the BIOS, as needed, if using Tools and Drivers CD
1.3.1 and beyond.
● To configure preinstalled Solaris using ttya: Set the External Serial Port to SP
and the External Serial Port Config to COM1 (default setting).
● To configure preinstalled Solaris using ttyb: Set the External Serial Port to
SYSTEM and the External Serial Port to Config to COM2.
Hardware and BIOS
The following issues apply to the Sun Fire X4150 server hardware and BIOS:
■ “Hard Drives Can Be Difficult to Remove From Right-Side Drive Bays” on
page 15
■ “32GB SSD Available for Sun Fire X4150” on page 16
■ “Enabling Open I/O AT Feature in BIOS Setup Menu” on page 18
■ “Serial Console Does Not Show the Host Reboot After the Sharing Owner Is Set in
ILOM” on page 18
■ “Possible Firmware Update Needed for Qimonda DIMMs” on page 18
■ “Identifying E0 Stepping Processors” on page 19
■ “BIOS Serial Port Default Settings Have Changed for Tools and Drivers CD 1.3.1”
on page 19
■ “Use of the F12 Key with Remote Keyboard” on page 24
■ “Update LSI 3081E Firmware to the Latest Version” on page 24
■ “DIMM Population Rules” on page 24
■ “Scripting the SP/BIOS Flash Process” on page 25
To Next Page
Loading...
